Charging Nest Instructions

VIDEO INSTRUCTIONS BELOW

STEP 1

Remove the allen wrench from the bottom of the nest base.

 

STEP 2
Remove the adapter by loosening the set screw "A" and pushing it out from the top of the nest.

 

STEP 3
Insert the charging cable through the bottom of the adapter. Be sure to note orientation for micro usb and 30 pin cables.

 

STEP 4
Secure cable by using the allen wrench to tighten set screw "B". Do not over tighten. Adjust height of cable if you have a case on your device.

 

STEP 5
Position the adapter so that set screw "A" is next to the cable channel. Angle adapter so it slides into grooves, then push down other side.

 

STEP 6
Adjust lateral position of the pin at the top of the nest to accommodate device.

 

STEP 7
Tighten set screw "A" to lock the adapter in place. Run cable through cable channel.

 

STEP 8
Place the allen wrench back into base, it will snap into place.